News

The Multishot Injection Molding Process Illustrated in Video

February 17, 2010 -- Do you have two minutes?  If you do then you have time to check out the new Rolco Inc. video on YouTube that illustrates the multishot injection molding process...

New 2-Shot Machine and ITAR Registry Demonstrate Rolco's Responsiveness to Customer Needs

September 17, 2009 -- In an economic season that has forced many businesses to delay or cancel their plans for capital improvements, Rolco has purchased... 

Rolco Inc. Releases White Paper

June 18 , 2009 -- Insert molding, two-shot molding, multishot molding:  Is there a difference or are these three terms referring to the same thing? More...

One Part Is Better Than Two

April 16, 2009 -- What if you could take two assembled components and turn them into one homogenous part with multishot molding?   More....

Deeper Engineering Department and New General Manager at Rolco

February 16, 2009 -- The Engineering and Technology capabilities at Rolco inc. have become stronger with new staff and fresh focus.  More...